To change cabinet knobs and pulls, you can follow these general steps:
Gather the necessary tools: You'll typically need a screwdriver, measuring tape (if you want to ensure accurate placement), and a template (optional, but helpful for consistent spacing).
Remove the old knobs/pulls: Use a screwdriver to unscrew and remove the existing knobs or pulls from the cabinets. The screws are usually located on the interior side of the door or drawer.
Measure and mark: If you want to ensure accurate placement of the new knobs or pulls, use a measuring tape and mark the desired location on the cabinet door or drawer. This step is optional if you're using a template.
Prepare the new hardware: If necessary, assemble the new knobs or pulls according to the manufacturer's instructions. Some may require inserting screws or other components.
Install the new hardware: Place the knob or pull in the desired location on the cabinet door or drawer. From the interior side, insert the screws through the holes of the hardware and tighten them using a screwdriver. Make sure not to overtighten to avoid damaging the cabinet.
Repeat for all cabinets: Repeat the above steps for each cabinet, drawer, or door where you want to change the hardware.
It's worth noting that the specific steps and tools required may vary depending on the type of cabinets and hardware you have. For example, some knobs may require a different type of fastening, such as a bolt or a nut. Always refer to the manufacturer's instructions that come with the new hardware for any specific guidelines or recommendations.
If you're uncertain or uncomfortable with the process, it's advisable to consult a professional handyman or a cabinet installer who can assist you with the task.